Electric Supercharger To Front Junction Box Cables (G2422533): Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- Note the position of the cables to aid installation.
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING
- Power down the Mild Hybrid Electric Vehicle (MHEV) system.
Refer to: MHEV POWER DOWN/UP
- Remove the engine cover.
Refer to: ENGINE COVER - INGENIUM I6 3.0L PETROL
- Remove the secondary bulkhead center panel.
Release the 2 breather pipes from the clip.
- Disconnect the electrical connector from the electric supercharger.
- Remove the bracket bolt.
- Remove the ground cable bolt.
- Remove the transmission undershield.
Refer to: TRANSMISSION UNDERSHIELD
-
CAUTION: Make sure there is no tension on the coolant hoses when the oil cooler is removed. Use suitable equipment to support the oil cooler.
- Remove the bolt.
- Release the oil cooler from the 2 clips and tie aside.
- Remove the 2 fasteners.
- Release the clip.
- Release the coolant hoses from the bracket.
- Disconnect the electrical connector from the MHEV battery junction box.
- Release the wiring harness clip.
- Remove the bolt.
- Remove the rear driveshaft.
Refer to: REAR DRIVESHAFT
- Remove the front driveshaft.
Refer to: FRONT DRIVESHAFT
Lower the height of the transmission jack by 20 mm.
General Equipment: Transmission jack
- Release the 2 breather pipes from the 2 clips.
- Remove the 2 bolts.
- Release the wiring harness bracket.
Remove the MHEV battery junction box to electric supercharger cables.