LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 90 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Cooling - INGENIUM I6 3.0L Petrol -- Defender/L663) >> Engine Cooling - INGENIUM I6 3.0L Petrol (G2344343) >> Removal And Installation >> Charge Air Cooler Coolant Pump (G2423958) >> Installation

Charge Air Cooler Coolant Pump (G2423958): Installation

WARNING: This page is about a different variant/trim than selected.
    • Install the 2 brackets.
    • Install the clip.
    • Install the charge air cooler coolant pump.
    • Install and tighten the bolt.

      Torque  : 5.4 Nm 

    • Connect the 2 coolant hoses.
    • Install the 2 clamps.
    • Connect the electrical connector.
  3. Install the engine undershield.

    Refer to: ENGINE UNDERSHIELD

  4. Connect the startup battery ground cable.

    Refer to: 12V SYSTEM DISCONNECT AND CONNECT

  5. Fill the engine cooling system with the correct amount of coolant fluid.

    Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING 

scientia non olet · About LEMON Manuals