Spark Plugs (G2344517): Removal

WARNING: This page is about a different variant/trim than selected.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Disconnect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT
Position the charge air cooler in the service position.
Refer to: CHARGE AIR COOLER SERVICE POSITION
Remove the air filter outlet pipe.
Refer to: AIR FILTER OUTLET PIPE
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the Noise, Vibration and Harshness (NVH) material.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the fuel injector wiring harness electrical connector.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the NVH material.
- Remove the 2 bolts.
- Remove the cover.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the breather pipe.
- Reposition the breather pipe away from the ignition coils.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the 6 electrical connectors.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 6 bolts.
- Remove the 6 ignition coils.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Use the special tool to remove the 6 spark plugs.

Special Tool(s): 303-1450