Right Engine Mount (G2796557): Removal

The following step(s) applies to: 

All vehicles 

1. Raise and support the vehicle on a suitable 2 post lift.

   Refer to: JACKING AND LIFTING

2. Disconnect the 12 V system.

   Refer to: 12V SYSTEM DISCONNECT AND CONNECT

3. Remove the exhaust system.

   Refer to: EXHAUST SYSTEM

4. Remove the starter motor.

   Refer to: STARTER MOTOR

The following step(s) applies to: 

Right hand drive vehicles 

1. CAUTION: Align the steering to the straight ahead position. Do not allow the steering wheel to rotate when the steering column is disconnected.

   Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

   • Remove and discard the steering column lower shaft lower bolt.
   • Reposition the steering column shaft.

   The following step(s) applies to: 

   All vehicles 

2. Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

   • Remove the ground cable bolt.
   • Release the ground cable from the engine mount bracket.

3. Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

   Remove the right engine mount nut.

4. CAUTION: Make sure that a suitable material, a wooden or rubber block is used to support the engine.

   Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

   Use a suitable hydraulic jack to support the engine.

   General Equipment: Transmission jack 

5. Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

   Remove the 4 engine mount bolts.

6. Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

   • Remove the 4 engine mount bracket bolts.
   • Reposition the engine mount bracket.

7. Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

   Remove the right engine mount.