Left Exhaust Manifold (G2796542): Removal

WARNING: This page is about a different variant/trim than selected.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING
Disconnect the 12V system.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT
Remove the exhaust system.
Refer to: EXHAUST SYSTEM
Remove the Air Conditioning (A/C) compressor.
Refer to: AIR CONDITIONING COMPRESSOR - V8 S/C 5.0L PETROL
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the bolt.
- Remove the Heated Oxygen Sensor (HO2S) electrical connector heatshield.
- Disconnect the HO2S electrical connector.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the banjo bolt.
- Disconnect the pipe clamp.
- Remove differential pressure sensor pipe.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 4 bolts.
- Remove the left exhaust manifold heatshield.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Use the special tool to remove and discard the 8 bolts.
  Special Tool(s): JLR-303-1652
- Remove the 8 spacers.
- Remove the left exhaust manifold.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove and discard the left exhaust manifold gasket.
NOTE: Do not disassemble further if the component is removed for access only.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Use the special tool to remove the HO2S from the left exhaust manifold.

Special Tool(s): 310-121