Crankshaft Rear Seal (G2796539): Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING
- Disconnect the 12V system.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT
- Remove the drive plate.
Refer to: DRIVE PLATE
- Remove the 12 bolts.
- Remove and discard the crankshaft rear seal and cover.