LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 90 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine - V8 S/C 5.0L Petrol -- Defender/L663 (1 Of 2)) >> Engine - V8 S/C 5.0L Petrol (G2796528) >> Removal And Installation >> Crankshaft Pulley (G2796537) >> Removal

Crankshaft Pulley (G2796537): Removal

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2-post lift.

    Refer to: JACKING AND LIFTING

  2. Disconnect the 12V system.

    Refer to: 12V SYSTEM DISCONNECT AND CONNECT

  3. Remove the accessory drive belt.

    Refer to: ACCESSORY DRIVE BELT

  4. Remove the windshield washer reservoir.

    Refer to: WINDSHIELD WASHER RESERVOIR - V8 S/C 5.0L PETROL

  5. Remove the starter motor.

    Refer to: STARTER MOTOR

  6. G14052016Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Install the special tool.

      Special Tool(s): JLR-303-1304 

    • Install and tighten the 2 bolts.

      Torque  : 10 Nm 

  7. G14052006Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Remove the 2 bolts.

  8. G14052007Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Install the special tools.

    Special Tool(s): 303-1437  , 303-1438 

    Torque  : 25 Nm 

  9. NOTE: The thread is left handed.
    G14052008Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Use a suitable stand to support the special tool.
    • Use the special tool to remove the bolt.
    • Discard the bolt.
  10. G14052009Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Remove the 2 bolts.

  11. G14052010Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Install the special tool.

    Special Tool(s): 303-1440 

  12. G14052011Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Install the special tool.

    Special Tool(s): 303-1441 

  13. G14052012Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Install the special tool.

      Special Tool(s): 303-1439 

    • Install and tighten the 4 bolts.

      Torque  : 10 Nm 

  14. G14052013Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Use the special tools to remove the crankshaft pulley.

  15. G14052014Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Remove the 4 bolts.
    • Remove the special tool.

      Special Tool(s): 303-1439 

  16. G14052015Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Remove the special tools.

    Special Tool(s): 303-1440  , 303-1441 

  17. G14052016Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Remove the 2 bolts.
    • Remove the special tool.

      Special Tool(s): JLR-303-1304 

scientia non olet · About LEMON Manuals