Crankshaft Front Seal (G2796538): Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- Disconnect the 12V system.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT
- Raise and support the vehicle on a suitable 2-post lift.
Refer to: JACKING AND LIFTING
- Remove the crankshaft pulley.
Refer to: CRANKSHAFT PULLEY
Use the special tool to remove and discard the crankshaft front seal.
Special Tool(s): 303-1434