Auto Stop/Start System Inhibits
WARNING: This page is about a different variant/trim than selected.
The inhibit conditions listed below will not set Diagnostic Trouble Code(s) but will set flags which can be viewed using the Jaguar Land Rover approved diagnostic equipment - Datalogger/Powertrain Control Module (PCM). Normal auto stop/start system operation will resume when an inhibit condition is no longer present, but the battery related inhibits may persist for some time.
NOTE:
- Performing a DTC clear on a petrol (gasoline) engine vehicle will inhibit the auto stop/start system.
- Do not reset the Battery Monitoring Sensor (BMS) to rectify battery condition inhibits. This may temporarily restore auto stop/start system operation but will lead to a recurrence of the fault.
| INHIBITS |
|---|
|