LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 90 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Exhaust System - V8 S/C 5.0L Petrol -- Defender/L663) >> Exhaust System - V8 S/C 5.0L Petrol (G2796740) >> Removal And Installation >> Left Catalytic Converter (G2796743) >> Installation

Left Catalytic Converter (G2796743): Installation

WARNING: This page is about a different variant/trim than selected.
  1. CAUTION:
    • Make sure the anti-seize compound does not contact the HO2S  tip.
    • If accidentally dropped or knocked install a new HO2S  .
    • Make sure the HO2S  wiring harness is not twisted, or damaged and is not in contact with either the exhaust or driveshaft.
    NOTE: If the original HO2S  is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the HO2S  .

    Use the special tool to install and tighten the 2 HO2S  .

    Special Tool(s): JLR-309-004 

    Torque  : 48 Nm 

  2. Install the left catalytic converter.
  3. Install the exhaust system.

    Refer to: EXHAUST SYSTEM 

    • Align the exhaust system.
    • Fully tighten the left catalytic converter clamp.

      Torque  : 55 Nm 

  5. Connect the 12 V system.

    Refer to: 12V SYSTEM DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals