Exhaust Center Section
WARNING: This page is about a different variant/trim than selected.
| ITEM | DESCRIPTION |
|---|---|
| 1 | Clamp (quantity 2) |
| 2 | Rubber mounts (quantity 2) |
| 3 | Resonator |
The 2 outlet pipes from the exhaust front section connect to the inlet pipes of the center resonator and secured by 2 clamps. The 2 inlet pipes are attached to the resonator. From the resonator the exhaust gases exit through 2 outlet pipes. The 2 outlet pipes connect directly to the rear silencer.
In production, the center section and the rear section are installed as one component. In service, the resonator can be replace independently and secure with 2 additional service clamps.
The 2 rubber mounts are connected to a mounting bracket which is bolted to the vehicle body, to support the exhaust center section.