LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 90 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Battery, Mounting And Cables - Vehicles With: PHEV -- Defender/L663) >> Battery, Mounting And Cables - Vehicles With: PHEV (G2608197) >> Removal And Installation >> PHEV Battery Coolant Heater (G2769701) >> Installation

PHEV Battery Coolant Heater (G2769701): Installation

WARNING: This page is about a different variant/trim than selected.
    • Install the PHEV  battery coolant heater.
    • Install and tighten the 3 nuts.

      Torque  : 10 Nm 

  2. Connect the 2 coolant hoses.
    • Connect the electrical connector.
    • Install the 2 wiring harness clips.
  4. Fill and bleed the PHEV  battery cooling system.

    Refer to: PHEV BATTERY COOLING SYSTEM DRAINING AND VACUUM FILLING 

scientia non olet · About LEMON Manuals