Drive Plate - INGENIUM I4 2.0L Petrol (G2344494): Installation

CAUTION: Do not insert the bottoming tap more than the depth of the threaded holes (16mm). Apply tape to the bottoming tap 16mm from the end as a visual guide.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Use a suitable bottoming tap to clean the threads.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the drive plate.
- Install and tighten the 8 new bolts.
  Renew Part: Drive plate bolt(s) Quantity: 8 .
  
  Torque
  
  Stage 1: 30 Nm
  
  Stage 2: 120°
Remove the special tool.
Special Tool(s): JLR-303-1630
- Install the bracket.
- Install and tighten the 2 bolts.
  Torque : 40 Nm
- Position the wiring harness in the correct location.
- Install the 4 wiring harness clips.
- Install the transmission cooler pipes.
- Install and tighten the 2 nuts.
  Torque : 12 Nm
- Install the wiring harness clip.
Install the transmission.
Refer to: TRANSMISSION - INGENIUM I4 2.0L PETROL
Install the charge air cooler.
Refer to: CHARGE AIR COOLER - INGENIUM I4 2.0L PETROL
Connect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT