Engine Cooling - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV (G2341925): Description: Radiator
| ITEM | DESCRIPTION |
|---|---|
| 1 | Hose connection - Coolant expansion tank |
| 2 | Hose connection - Radiator upper hose |
| 3 | Top mount (quantity 2) |
| 4 | Hose connection - Charge air cooler and auxiliary radiator |
| 5 | Bleed screw |
| 6 | Hose connection - Radiator lower hose |
| 7 | Lower mount (quantity 2) |
| 8 | Hose connection - Automatic Transmission Fluid (ATF) warming valve |
The radiator is a vertical flow type with an aluminum core and plastic end tanks in the upper and lower position of the radiator. The radiator uses brazed aluminum tube technology to reduce weight. A low temperature zone is located at the left side of the radiator and provides cooled engine coolant for the Automatic Transmission Fluid (ATF) cooler.
The radiator is located in the vehicle by locating spigots and supports integrated into the end tanks. The supports are installed in rubber isolator bushes in the lower support bracket. The upper mounting of the end tanks is attached to the vehicle body through the hood latch panel.
A drain plug is integrated into the lower end tank on the left side. Engine coolant outlet and inlet connections are incorporated into the upper and lower end tanks respectively. The lower end tank also has a connection for engine coolant outlet to the ATF cooler and to the auxiliary radiator.
There is a connection to the charge air radiator to allow filling and bleeding of the charge air cooling system.