Engine Front Cover - INGENIUM I4 2.0L Petrol - PHEV (G2748113): Removal
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING
- Drain the engine oil.
Refer to: ENGINE OIL VACUUM DRAINING AND FILLING
- Disconnect the 12 V system.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT
- Remove the crankshaft pulley.
Refer to: CRANKSHAFT PULLEY - INGENIUM I4 2.0L PETROL - PHEV
- Remove the Belt Integrated Starter Generator (BISG) belt upper tensioner.
Refer to: BELT INTEGRATED STARTER GENERATOR DRIVE BELT UPPER TENSIONER - INGENIUM I4 2.0L PETROL - PHEV
- Remove the 14 bolts.
- Remove the engine front cover.