Turbocharger - INGENIUM I4 2.0L Petrol - PHEV (G2748213): Description: Turbocharger
| ITEM | DESCRIPTION |
|---|---|
| 1 | Turbocharger wastegate actuator link rod |
| 2 | Turbocharger wastegate actuator |
| 3 | Oil supply pipe connection |
| 4 | Compressor housing |
| 5 | Engine coolant outlet connection |
| 6 | Engine coolant inlet connection |
| 7 | Turbine housing |
| 8 | Turbocharger wastegate valve |
| 9 | Turbine inlet connection |
| 10 | Exhaust gas outlet connection |
| 11 | Oil return pipe connection |
| 12 | Charge air outlet connection |
| 13 | Clean air inlet connection |
The turbocharger is attached to the cylinder head with 4 studs and nuts and a multilayer steel gasket.
The turbocharger is equipped with ball bearings. The ball bearings provide significant performance improvements to the turbocharger, improving the vehicle transient response. The ball bearings are also more efficient than a standard journal bearing.
The turbocharger utilizes a twin scroll turbine housing. The turbocharger has 2 turbine inlets and separates the exhaust flow into pairs of cylinders. The upper turbine inlet is connected to the second and third cylinder. The lower turbine inlet is connected to the first and fourth cylinder.
The turbocharger wastegate actuator is attached to the compressor housing with 3 bolts. The turbocharger wastegate actuator operates the turbocharger wastegate valve and allows the exhaust gas to bypass the turbine wheel. The turbocharger wastegate actuator contains a position sensor. The position sensor and the actuator motor are connected to the Powertrain Control Module (PCM). The turbocharger wastegate actuator is controlled by a Pulse Width Modulated (PWM) signal from the PCM .