Electric Supercharger Cooling 3.0L MHEV
WARNING:
- A risk assessment must be performed before any work is undertaken.
- All hybrid electric vehicle work must be performed by a suitably qualified person.
- Appropriate Personal Protection Equipment must be worn when working on or near a hybrid electric vehicle high voltage system.
- The hybrid electric vehicle battery pack casing must not be opened due to the risk of exposure to hazardous voltage, which may cause serious injury or death.
- The electric power inverter converter casing must not be disassembled due to the risk of exposure to hazardous voltage, which may cause serious injury or death.
- If the hybrid electric vehicle battery pack is damaged or overcharged, there is a risk of exposure to hazardous voltage and/or highly corrosive electrolyte mist. If liquid or vapor is observed leaking from the hybrid electric vehicle battery pack, take the following action:
- Evacuate the area
- Notify manager
- Do not breathe smoke/vapour
- Contain spillage using spill kit
- Wash any spillage off body and clothing (remove contaminated clothing)
- If the hybrid electric vehicle warning indicator is illuminated, the Battery Energy Control Module (BECM) cannot isolate the high voltage cables. Live working will be necessary to rectify the fault.
- The motor generator can generate a voltage if the wheels are rotated, even if the hybrid electric vehicle system has been made safe.
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT
acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle.
NOTE:
- If a control module or a component is at fault or may be at fault and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual, or determine if any prior approval program is in operation, prior to the installation of a new module/component.
- Generic scan tools may not read the codes listed, or may read only 5-digit codes. Match the 5 digits from the scan tool to the first 5 digits of the 7-digit code listed to identify the fault (the last 2 digits give extra information read by the manufacturer-approved diagnostic system).
- When performing voltage or resistance tests, always use a digital multimeter that has the resolution ability to view 3 decimal places. For example, on the 2 volts range can measure 1mV or 2 K Ohm range can measure 1 Ohm. When testing resistance always take the resistance of the digital multimeter leads into account.
- Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests.
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion.
- If Diagnostic Trouble Code(s) are recorded and, after performing the pinpoint tests, a fault is not present, an intermittent concern may be the cause. Always check for loose connections and corroded terminals.
- Check JLR claims submission system for open campaigns. Refer to the corresponding bulletins and SSMs which may be valid for the specific customer complaint and complete the recommendations as required.
VISUAL INSPECTION DESCRIPTION
| MECHANICAL | ELECTRICAL |
|---|---|
|
|
|
|
|
|
|
|
|
|
|
|