Oil Pump Drive Chain (G2344503): Installation

WARNING: This page is about a different variant/trim than selected.

- Install the oil pump drive chain and sprocket.
- Use the special tool to hold the oil pump drive sprocket.
  Special Tool(s): 205-053
- Install and tighten the new bolt.
  Renew Part: Oil pump gear bolt Quantity: 1 .
  
  Torque
  
  Stage 1: 60 Nm
  
  Stage 2: 90°
Install the engine front cover.
Refer to: ENGINE FRONT COVER
Connect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT