Crankshaft Front Seal (G2344456): Installation
WARNING: This page is about a different variant/trim than selected.
- CAUTION:
- Make sure that the area around the component is clean and free of foreign material.
- Take extra care not to damage the seal.
Use the special tool to install the new crankshaft front seal.
Special Tool(s): JLR-303-1628
Renew Part: Crankshaft front oil seal Quantity: 1 .
Torque : 30 Nm
- Install the crankshaft pulley.
Refer to: CRANKSHAFT PULLEY
- Connect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT