LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 110 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine - INGENIUM I6 3.0L Petrol -- Defender/L663) >> Engine - INGENIUM I6 3.0L Petrol (G2344340) >> Removal And Installation >> Continuous Variable Valve Lift Oil Temperature Sensor (G2344497) >> Installation

Continuous Variable Valve Lift Oil Temperature Sensor (G2344497): Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install and tighten the CVVL  oil temperature sensor.

    Torque  : 18 Nm 

  2. Connect the electrical connector to the CVVL  oil temperature sensor.
  3. Install the engine cover.

    Refer to: ENGINE COVER - INGENIUM I6 3.0L PETROL

  4. Connect the 12 V system.

    Refer to: 12V SYSTEM DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals