Right Variable Camshaft Timing Solenoid (G2849401): Installation

WARNING: This page is about a different variant/trim than selected.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Lubricate the VCT solenoid O-ring seal with clean engine oil.
- Install the VCT solenoid.
- Install and tighten the 2 bolts.
  Torque : 10 Nm
- Connect the electrical connector to the VCT solenoid.
- Install the coolant hose assembly.
- Connect the 2 coolant pipes.
- Secure the 2 clips.
- Secure the 3 hose clamps.
- Install the clean air duct.
- Tighten the clamp.
  Torque : 3.5 Nm
Install the air cleaner outlet pipe T-connector.
Refer to: AIR CLEANER OUTLET PIPE T-CONNECTOR
Vacuum fill the engine cooling system.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING
Connect the 12V system.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT