LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 110 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Electronic Engine Controls - V8 S/C 5.0L Petrol -- Defender/L663) >> Electronic Engine Controls - V8 S/C 5.0L Petrol (G2796672) >> Removal And Installation >> Right Mid Catalyst Heated Oxygen Sensor (G2796692) >> Removal

Right Mid Catalyst Heated Oxygen Sensor (G2796692): Removal

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: JACKING AND LIFTING

  2. Remove the transmission undershield.

    Refer to: TRANSMISSION UNDERSHIELD

  3. G15306864Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Disconnect the electrical connector from the right mid catalyst Heated Oxygen Sensor (HO2S).
    • Release the wiring harness from the clip.
  4. G15306865Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Use the special tool to remove the right mid catalyst HO2S  .

    Special Tool(s): JLR-309-004 

scientia non olet · About LEMON Manuals