LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 110 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Electronic Engine Controls - V8 S/C 5.0L Petrol -- Defender/L663) >> Electronic Engine Controls - V8 S/C 5.0L Petrol (G2796672) >> Removal And Installation >> Powertrain Control Module (G2796677) >> Installation

Powertrain Control Module (G2796677): Installation

WARNING: This page is about a different variant/trim than selected.
    • Install the PCM  to the bracket.
    • Install and tighten the 4 nuts.

      Torque  : 7 Nm 

    • Install the PCM  assembly to the vehicle.
    • Install and tighten the 2 nuts.

      Torque  : 9 Nm 

  3. Connect the 2 electrical connectors to the PCM  .
    • Install the access cover.
    • Install the 5 clips.
  5. Connect the 12 V system.

    Refer to: 12V SYSTEM DISCONNECT AND CONNECT

  6. NOTE:
    • This step is only required if a new component is installed.
    • SRO to be claimed separately.
    • Use the Jaguar Land Rover (JLR) approved diagnostic equipment to configure the new module.

      General Equipment: Jaguar Land Rover approved diagnostic equipment 

    • Follow all on-screen instructions to complete this task.
scientia non olet · About LEMON Manuals