Crankshaft Position Sensor (G2796676): Removal
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING
- Remove the engine undershield.
Refer to: ENGINE UNDERSHIELD
- Remove the transmission undershield.
Refer to: TRANSMISSION UNDERSHIELD
- Disconnect the electrical connector from the Crankshaft Position Sensor (CKP).
- Remove the bolt.
- Remove the CKP .