DTC P0327-11: Knock Sensor 1 Circuit Low (Bank1) - Circuit short to ground: Action
WARNING: This page is about a different variant/trim than selected.
- Vehicle Conditions to enable DTC
Logging Strategy
- Normal driving
- Prioritized Checks to Perform
- Refer to the electrical circuit diagrams and check knock sensor circuit for short circuit to ground
- Measure knock sensor circuit for correct resistance
- Knock sensor resistance should be greater than 4 Mega Ohms
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Using the Jaguar Land Rover approved diagnostic equipment, clear the Diagnostic Trouble Code(s) and retest
- Install new knock sensor, only when diagnosed as failed