LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 110 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Electronic Engine Controls - INGENIUM I6 3.0L Petrol -- Defender/L663) >> Electronic Engine Controls - INGENIUM I6 3.0L Petrol >> Removal And Installation >> Rear Knock Sensor (G2344550) >> Installation

Rear Knock Sensor (G2344550): Installation

WARNING: This page is about a different variant/trim than selected.
    • Install the knock sensor.
    • Install and tighten the bolt.

      Torque  : 20 Nm 

    • Connect the electrical connector.
    • Install the wiring harness to the clip.
  3. Install the engine undershield.

    Refer to: ENGINE UNDERSHIELD

  4. Connect the startup battery ground cable.

    Refer to: 12V SYSTEM DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals