Pre Catalyst Heated Oxygen Sensor (G2344544): Installation

WARNING: This page is about a different variant/trim than selected.

CAUTION:
- Make sure that the mating faces are clean and free of foreign material.
- If accidentally dropped or knocked install a new sensor.
Use the special tool to install and tighten the pre catalyst heated oxygen sensor.

Special Tool(s): JLR-303-1666

Torque : 48 Nm
- Connect the electrical connector.
- Install the wiring harness into the 2 clips.
- Install the pipe assembly.
- Install the 3 clips.
Install the right air filter outlet pipe.
Refer to: AIR FILTER OUTLET PIPE
Install the right air filter housing.
Refer to: AIR FILTER HOUSING
Install the engine cover.
Refer to: ENGINE COVER - INGENIUM I6 3.0L PETROL