LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 110 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Electronic Engine Controls - INGENIUM I6 3.0L Petrol -- Defender/L663) >> Electronic Engine Controls - INGENIUM I6 3.0L Petrol >> Removal And Installation >> Oil Pressure And Temperature Sensor (G2318746) >> Installation

Oil Pressure And Temperature Sensor (G2318746): Installation

WARNING: This page is about a different variant/trim than selected.
    • Install and tighten the oil pressure and temperature sensor.

      Torque  : 15 Nm 

    • Connect the electrical connector.
  2. Install the cooling fan.

    Refer to: VISCOUS COOLING FAN

  3. Connect the startup battery ground cable.

    Refer to: SPECIFICATIONS

  4. Check and top up the engine with oil.

    Refer to: SPECIFICATIONS

scientia non olet · About LEMON Manuals