LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 110 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Electronic Engine Controls - INGENIUM I6 3.0L Petrol -- Defender/L663) >> Electronic Engine Controls - INGENIUM I6 3.0L Petrol >> Removal And Installation >> Manifold Absolute Pressure And Temperature Sensor (G2344549) >> Installation

Manifold Absolute Pressure And Temperature Sensor (G2344549): Installation

WARNING: This page is about a different variant/trim than selected.
    • Reposition the coolant hose.
    • Install the Manifold Absolute Pressure and Temperature (MAPT) sensor.
    • Install and tighten the bolt.

      Torque  : 4.1 Nm 

    • Connect the electrical connector.
  2. Install the air filter outlet pipe.

    Refer to: AIR FILTER OUTLET PIPE

  3. Connect the startup battery ground cable.

    Refer to: 12V SYSTEM DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals