LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 110 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Electronic Engine Controls - INGENIUM I6 3.0L Petrol -- Defender/L663) >> Electronic Engine Controls - INGENIUM I6 3.0L Petrol >> Removal And Installation >> Exhaust Back Pressure Sensor (G2823218) >> Installation

Exhaust Back Pressure Sensor (G2823218): Installation

WARNING: This page is about a different variant/trim than selected.
    • Install the exhaust back pressure sensor to the bracket.
    • Install and tighten the bolt.

      Torque  : 8 Nm 

    • Install the exhaust back pressure sensor and bracket to the engine.
    • Install and tighten the 2 nuts.

      Torque  : 24 Nm 

    • Connect the hose.
    • Connect the electrical connector.
    • Secure the wiring harness to the clip.
    • Install the transmission undershield.
    • Install and tighten the 20 bolts.

      Torque  : 10 Nm 

scientia non olet · About LEMON Manuals