LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 110 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Electronic Engine Controls - INGENIUM I6 3.0L Petrol -- Defender/L663) >> Electronic Engine Controls - INGENIUM I6 3.0L Petrol >> Removal And Installation >> Cylinder Block Temperature Sensor (G2300675) >> Installation

Cylinder Block Temperature Sensor (G2300675): Installation

WARNING: This page is about a different variant/trim than selected.
  1. CAUTION: Make sure all the mating faces are clean and free from foreign material.
    • Use the special tool to install and tighten the cylinder block temperature sensor.

      Special Tool(s): 303-680 

      Torque  : 10.5 Nm 

    • Connect the electrical connector.
    • Install the electrical connector to the bracket.
  2. Install the front driveshaft.

    Refer to: FRONT DRIVESHAFT

  3. Install the engine undershield.

    Refer to: ENGINE UNDERSHIELD

  4. Connect the startup battery ground cable.

    Refer to: 12V SYSTEM DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals