LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 110 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Electronic Engine Controls - INGENIUM I6 3.0L Petrol -- Defender/L663) >> Electronic Engine Controls - INGENIUM I6 3.0L Petrol >> Removal And Installation >> Crankshaft Position Sensor (G2344545) >> Installation

Crankshaft Position Sensor (G2344545): Installation

WARNING: This page is about a different variant/trim than selected.
    • Install the crankshaft position sensor.
    • Install and tighten the bolt.

      Torque  : 8 Nm 

    • Connect the electrical connector.
  2. Install the transmission undershield.

    Refer to: TRANSMISSION UNDERSHIELD

  3. Connect the 12 V system.

    Refer to: 12V SYSTEM DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals