Fuel Tank - 110 (G2796785): Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: Steps 1-4 are only required if previously removed.
- Install the LP fuel pump assembly.
- Connect the fuel line to the LP fuel pump assembly.
- Connect the electrical connector.
- Install a new LP fuel pump assembly O-ring seal.
  Renew Part: Fuel pump O-ring seal Quantity: 1 .
- Reposition the LP fuel pump assembly in the correct position.
- Use the special tool to install and tighten the LP fuel pump assembly retaining ring.
  Special Tool(s): 310-123
- Install the fuel tank to the heatshield.
- Install and tighten the 4 bolts.
  Torque : 10 Nm
- Install the fuel line to the fuel tank at the 4 clips.
- Connect the fuel line to the LP fuel pump assembly.
WARNING: This step requires the aid of another technician.
- Use the transmission jack to install the fuel tank.
  General Equipment: Transmission jack
- Install the fuel tank rear center bracket.
- Install and tighten the 7 bolts.
  Torque : 48 Nm
- Install the fuel filler hose to the fuel tank.
- Install and tighten the clamp.
  Torque : 3.5 Nm
- Install the 2 rear brackets.
- Install and tighten the 7 nuts.
  Torque : 48 Nm
- Install the 2 undershield brackets.
- Install and tighten the 6 bolts.
  Torque : 10 Nm
Connect the fuel line.
Install the rear driveshaft.
Refer to: REAR DRIVESHAFT
Fill the fuel tank.
Refer to: FUEL TANK DRAINING
Connect the 12V system.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT
Bleed the fuel system.
Refer to: LOW-PRESSURE FUEL SYSTEM BLEEDING