Viscous Cooling Fan Shroud (G2805177): Removal

WARNING: This page is about a different variant/trim than selected.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Disconnect the 12V system.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT
Raise and support the vehicle on a suitable 2-post lift.
Refer to: JACKING AND LIFTING
Partially drain the engine cooling system.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING
Remove the viscous cooling fan.
Refer to: VISCOUS COOLING FAN
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the 2 coolant pipe connectors.
- Remove the coolant pipe.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the coolant hose clip.
- Disconnect the coolant hose connector.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the electrical connector.
- Release the coolant hose clip.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Release the 3 wiring harness bracket clips.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the bolt.
Remove the windshield washer reservoir.
Refer to: WINDSHIELD WASHER RESERVOIR - V8 S/C 5.0L PETROL
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the bolt.
- Release the transmission fluid cooler.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Release the 4 coolant hose clips.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the coolant hose clip.
- Disconnect the electrical connector.
- Remove the bolt.
- Release the auxiliary radiator coolant pump.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the 2 bolts.
NOTE: Note the position of the locating pegs prior to removal.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 2 bolts.
- Release the 2 clips.
- Remove the viscous cooling fan shroud.
NOTE: Do not disassemble further if the component is removed for access only.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the electrical connector clip.
- Release the 9 wiring harness clips.
- Remove the wiring harness.