Rear Coolant Manifold (G2796578): Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: This step is only required if new components are not installed.

Install 2 new O-ring seals to the rear coolant manifold.

Renew Part: Cylinder block coolant outlet O-ring seals Quantity: 2 .
- Install the rear coolant manifold.
- Install and tighten the 4 bolts.
  Torque : 9 Nm
- Install the electrical connector clip.
- Connect the electrical connector.
- Install the 2 wiring harness clips.
- Install the rear coolant manifold left hose.
- Install the clamp.
- Install the coolant hose to the 2 clips.
- Reposition the transmission breather pipe into the correct location.
- Install and tighten the bolt.
  Torque : 9 Nm
- Install the clip.
- Install the rear coolant manifold right hose.
- Connect the 2 coolant hose connectors.
- Install and tighten the bolt.
  Torque : 12 Nm
Install the secondary bulkhead center panel.
Refer to: SECONDARY BULKHEAD CENTER PANEL - V8 S/C 5.0L PETROL
Fill the engine cooling system with the correct amount of coolant fluid.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING
Connect the 12V system.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT