Oil Supply Pipe (G2327535): Installation

WARNING: This page is about a different variant/trim than selected.

- Install 2 new sealing washers.
  Renew Part: Oil supply pipe sealing washers Quantity: 2 .
- Install a new bolt.
  Renew Part: Turbocharger oil supply pipe banjo bolt Quantity: 1 .
- Install the oil supply pipe.
- Tighten the bolt.
  Torque : 18 Nm
- Install 2 new sealing washers.
  Renew Part: Oil supply pipe sealing washers Quantity: 2 .
- Install a new bolt.
  Renew Part: Turbocharger oil supply pipe banjo bolt Quantity: 1 .
- Tighten the bolt.
  Torque : 18 Nm
Install the charge air cooler inlet pipe.
Refer to: CHARGE AIR COOLER INLET PIPE
Connect the startup battery ground cable.
Refer to: SPECIFICATIONS