Fuel Tank - 90 (G2520079): Installation

WARNING: This page is about a different variant/trim than selected.

The following step(s) applies to:

All vehicles

NOTE: Steps 1-3 are only required if previously removed.
- Install the fuel pump.
- Connect the fuel line to the fuel pump.
- Connect the electrical connector.
- Install the fuel tank heatshield.
- Install and tighten the 4 bolts.
  Torque : 10 Nm
- Install the fuel line.
- Install the fuel line to the 5 clips.
- Connect the fuel line.
WARNING: This step requires the aid of another technician.
- Install the fuel tank.
- Install and tighten the 7 bolts.
  Torque : 48 Nm
- Install the fuel filler pipe to the fuel tank.
- Install and tighten the clip.
  Torque : 3.5 Nm
- Install the 2 brackets.
- Install and tighten the 7 nuts.
  Torque : 48 Nm
- Install the 2 rear body braces.
- Install and tighten the 6 nuts.
  Torque : 48 Nm
- Connect the fuel tank line.
- Install the fuel line to the clip.
The following step(s) applies to:

Vehicles with fuel fired booster heater
Connect the FFBH line connector.
The following step(s) applies to:

All vehicles
Install the rear driveshaft.
Refer to: REAR DRIVESHAFT
Fill the fuel tank.
Refer to: FUEL TANK DRAINING
Connect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT
Bleed the fuel system.
Refer to: LOW-PRESSURE FUEL SYSTEM BLEEDING