Fuel Pump Module - 110 (G2577294): Installation

WARNING: This page is about a different variant/trim than selected.

CAUTION: Make sure that the seal is correctly positioned. Failure to follow this instruction may result in damage to the vehicle.

Install a new O-ring seal to the fuel pump module.

Renew Part: Fuel pump O-ring seal Quantity: 1 .
- Install the fuel pump module to the fuel tank.
- Connect the fuel line.
- Connect the electrical connector.
- Make sure the fuel pump module is correctly aligned.
- Use the special tool 310-123 to tighten the fuel pump retaining ring.
  Special Tool(s): 310-123
Install the 2 fuel lines to the fuel pump module.
Connect the breather pipe to the fuel tank.
Connect the 2 electrical connectors to the fuel pump module.
- Reposition the wiring harness into the correct location.
- Install and tighten the 5 nuts.
  Torque : 6 Nm
Reposition the carpet.
NOTE: Vehicles with 5 seats.

Install the second row seat base frame.

Refer to: SECOND ROW SEAT BASE FRAME - 110, VEHICLES WITH: 5 SEATS, 40/60

Refer to: SECOND ROW SEAT - 110, BENCH TYPE
NOTE: Vehicles with 7 seats.

Install the second row right seat.

Refer to: SECOND ROW RIGHT SEAT
Connect the 12 V system.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT