MHEV Pass Through Assembly To Front Junction Box Cables (G2422551): Installation

WARNING: This page is about a different variant/trim than selected.

CAUTION: This step requires the aid of another technician.

Install the MHEV pass through assembly to front junction box cables.
- Install and tighten the MHEV cable rear bolt.
  Torque : 10 Nm
- Install and tighten the MHEV cable rear nut.
  Torque : 10 Nm
- Install the 3 MHEV cable rear clips.
Install and tighten the 3 MHEV cable center bolts.
Torque : 10 Nm
Install the 5 MHEV cable center clips.
- Install the 2 MHEV cable front clips.
- Install and tighten the bolt.
  Torque : 10 Nm
- Connect the MHEV cable rear electrical connector.
- Install the MHEV cable to the clip.
- Connect the MHEV cable front electrical connector.
- Install the 2 clips.
Install the rear subframe assembly.
Refer to: REAR SUBFRAME
Install the transmission undershield.
Refer to: TRANSMISSION UNDERSHIELD
Power up the MHEV system.
Refer to: MHEV POWER DOWN/UP