MHEV Pass Through Assembly - 90 (G2886131): Installation

WARNING: This page is about a different variant/trim than selected.

- Install the MHEV pass through assembly.
- Install and tighten the 4 bolts.
  Torque : 10 Nm
- Connect the underside electrical connector.
- Install the wiring harness into the clip.
Connect the loadspace electrical connector.
Install the rear subframe.
Refer to: REAR SUBFRAME
Install the second row seat.
Refer to: SECOND ROW SEAT - 90, BENCH TYPE
Power up the MHEV system.
Refer to: MHEV POWER DOWN/UP