MHEV Pass Through Assembly - 110 (G2422550): Installation
WARNING: This page is about a different variant/trim than selected.
The following step(s) applies to:
All vehicles
-
- Install the MHEV pass through assembly.
- Install and tighten the 4 bolts.
Torque : 10 Nm
-
- Connect the underside electrical connector.
- Install the wiring harness into the clip.
- Connect the loadspace electrical connector.
- Install the rear subframe.
Refer to: REAR SUBFRAME
The following step(s) applies to:
Vehicles with occasional rear seats
- Install the third row seat.
Refer to: THIRD ROW SEAT
The following step(s) applies to:
All vehicles
- Power up the MHEV
system.
Refer to: MHEV POWER DOWN/UP