LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 110 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Battery, Mounting And Cables - Vehicles With: MHEV -- Defender/L663) >> Battery, Mounting And Cables - Vehicles With: MHEV >> Removal And Installation >> MHEV Front Junction Box (G2422548) >> Installation

MHEV Front Junction Box (G2422548): Installation

WARNING: This page is about a different variant/trim than selected.
    • Install the MHEV  battery front junction box.
    • Install, but do not fully tighten the 3 nuts.
  2. Connect the 2 front electrical connectors.
    • Connect the rear electrical connector.
    • Install the 2 clips.
  4. Tighten the 3 nuts of the front MHEV  junction box.

    Torque  : 9 Nm 

  5. Install the transmission undershield.

    Refer to: TRANSMISSION UNDERSHIELD

  6. Power up the MHEV  system.

    Refer to: MHEV POWER DOWN/UP 

scientia non olet · About LEMON Manuals