MHEV Battery Tray - 90 (G2886132): Removal

WARNING: This page is about a different variant/trim than selected.

CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.

NOTE:

This procedure contains illustrations showing certain components removed to provide extra clarity.
This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.

Power down the Mild Hybrid Electric Vehicle (MHEV) system.
Refer to: MHEV POWER DOWN/UP
Remove the Direct Current to Direct Current (DC/DC) Convertor.
Refer to: DIRECT CURRENT TO DIRECT CURRENT CONVERTER - 90
Remove the MHEV battery.
Refer to: MHEV BATTERY
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the electrical connector.
- Remove the 2 bolts.
- Release the MHEV battery ground cable clip.
- Remove the MHEV battery tray.
NOTE: Do not disassemble further if the component is removed for access only.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Release the 4 wiring harness clips from the MHEV battery tray.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 2 nuts.
- Remove the DC/DC Converter cooling fan cover.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 2 bolts.
- Remove the DC/DC Converter cooling fan.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the wiring harness clip.
- Remove the 2 bolts.
- Remove the MHEV battery cooling fan.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 2 bolts.
- Remove the rear MHEV junction box.