MHEV Battery Housing Air Duct - 110 (G2422554): Installation

WARNING: This page is about a different variant/trim than selected.

The following step(s) applies to:

All vehicles

Install the MHEV battery housing air duct.
The following step(s) applies to:

Vehicles without occasional rear seats
Install the 2 clips.
- Reposition the rear floor carpet.
- Install the 4 clips.
Install the stowage compartment.
- Install the loadspace lower side trim.
- Install and tighten the 2 bolts.
  Torque : 24 Nm
- Install the 2 lower clips.
- Repeat this step for the other side.
Install the loadspace floor cover.
The following step(s) applies to:

Vehicles with occasional rear seats
Install the third row seats.
Refer to: THIRD ROW SEAT

The following step(s) applies to:

All vehicles
Connect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT