MHEV Battery Breather Hose (G2422560): Removal

WARNING: This page is about a different variant/trim than selected.

CAUTION:

Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
The Mild Hybrid Electric Vehicle (MHEV) battery breather hose is a single use component and must be replaced after removal.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Power down the MHEV system.
Refer to: MHEV POWER DOWN/UP
Remove the loadspace left side trim panel.
Refer to: LEFT LOADSPACE TRIM PANEL - [+] 7 SEAT CONFIGURATION, 110

Refer to: LEFT LOADSPACE TRIM PANEL - 110, VEHICLES WITH: 5 SEATS

Refer to: LEFT LOADSPACE TRIM PANEL - 90
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the 2 wiring harness clips.
- Disconnect the 5 electrical connectors.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 4 nuts.
- Remove the Audio Amplifier Module (AAM).
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the MHEV battery breather hose from the MHEV battery.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Release the 3 clips.
CAUTION: The 2 clips will break when released.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Use a suitable tool to release the MHEV battery breather hose connector.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove and discard the MHEV battery breather hose.