LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 110 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Battery, Mounting And Cables - Vehicles With: MHEV -- Defender/L663) >> Battery, Mounting And Cables - Vehicles With: MHEV >> Removal And Installation >> MHEV Battery (G2422562) >> Installation

MHEV Battery (G2422562): Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the MHEV  battery.
    • Install the 3 brackets.
    • Install and tighten the 6 bolts.

      Torque  : 10 Nm 

    • Install the MHEV  battery cover.
    • Install and tighten the 2 bolts.

      Torque  : 6 Nm 

    • Install and tighten the nut.

      Torque  : 6 Nm 

  4. Install the 2 wiring harness clips to the MHEV  battery cover.
  5. Connect the MHEV  battery breather hose to the MHEV  battery.
  6. Install the MHEV  battery air duct.

    Refer to: MHEV BATTERY HOUSING AIR DUCT - 110 

    Refer to: MHEV BATTERY HOUSING AIR DUCT - 90 

  7. Power up the MHEV  system.

    Refer to: MHEV POWER DOWN/UP 

  8. NOTE: Only complete this step if a new component was installed.
    • Run the following routines.
    • BECM_Replace ECU
    • MHEV_SOC
    • PCM/EPICD/BECM SW update
scientia non olet · About LEMON Manuals