Electric Supercharger To Front Junction Box Cables (G2422533): Installation

WARNING: This page is about a different variant/trim than selected.

Install the MHEV battery junction box to electric supercharger cables.
- Install the wiring harness bracket.
- Install and tighten the 2 bolts.
  Torque : 10 Nm
- Install the 2 breather pipes to the 2 clips.
Raise the transmission jack.
Install the front driveshaft.
Refer to: FRONT DRIVESHAFT
Install the rear driveshaft.
Refer to: REAR DRIVESHAFT
- Connect the electrical connector to the MHEV battery junction box.
- Install the wiring harness clip.
- Install and tighten the bolt.
  Torque : 10 Nm
- Install the coolant hoses to the bracket.
- Install the clip.
- Install the 2 fasteners.
- Install the oil cooler.
- Install and tighten the bolt.
  Torque : 10 Nm
Install the transmission undershield.
Refer to: TRANSMISSION UNDERSHIELD
- Install and tighten the ground bolt.
  Torque : 12 Nm
- Install and tighten the bracket bolt.
  Torque : 48 Nm
- Connect the electrical connector to the electric supercharger.
Install the 2 breather pipes to the clip.
Install the secondary bulkhead center panel.
Refer to: SECONDARY BULKHEAD CENTER PANEL - INGENIUM I4 2.0L PETROL/INGENIUM I4 2.0L PETROL - PHEV/INGENIUM I6 3.0L DIESEL/INGENIUM I6 3.0L PETROL
Install the engine cover.
Refer to: ENGINE COVER - INGENIUM I6 3.0L PETROL
Power up the MHEV system.
Refer to: MHEV POWER DOWN/UP