LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2022 >> Defender 110 S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Battery, Mounting And Cables - Vehicles With: MHEV -- Defender/L663) >> Battery, Mounting And Cables - Vehicles With: MHEV >> Removal And Installation >> Direct Current To Direct Current Converter Air Duct (G2422549) >> Installation

Direct Current To Direct Current Converter Air Duct (G2422549): Installation

WARNING: This page is about a different variant/trim than selected.

The following step(s) applies to: 

All vehicles 

    • Install the DC/DC  lower air duct.
    • Install and tighten the bolt.

      Torque  : 3.2 Nm 

    • Reposition the wiring harness.
    • Install the 2 clips to the DC/DC  cover.
  1. Install the 3 wiring harness clips.
  2. Install the DC/DC  upper air duct.
  3. Install the left loadspace trim panel.

    Refer to: LEFT LOADSPACE TRIM PANEL - [+] 7 SEAT CONFIGURATION, 110

    Refer to: LEFT LOADSPACE TRIM PANEL - 110, VEHICLES WITH: 5 SEATS

    Refer to: LEFT LOADSPACE TRIM PANEL - 90

    The following step(s) applies to: 

    Vehicles with occasional rear seats 

  4. Install the third row seat.

    Refer to: THIRD ROW SEAT

    The following step(s) applies to: 

    All vehicles 

  5. Power up the MHEV  system.

    Refer to: MHEV POWER DOWN/UP