Direct Current To Direct Current Converter - 90 (G2886130): Installation

WARNING: This page is about a different variant/trim than selected.

- Install the DC/DC .
- Install and tighten the 3 bolts.
  Torque : 6 Nm
- Install the DC/DC cover.
- Install and tighten the 2 bolts.
  Torque : 6 Nm
- Install and tighten the 3 bolts.
  Torque : 6 Nm
Install the 2 wiring harness clips to the left side of the DC/DC cover.
- Reposition the wiring harness into the correct location.
- Install the wiring harness clip.
- Connect the 3 cables.
- Install and tighten the 3 nuts.
  Torque
  
  M8: 12 Nm
  
  M6: 10 Nm
- Connect the electrical connector.
- Install the wiring harness clip.
Install the terminal cover.
Close the cover.
Install the DC/DC air duct.
Refer to: DIRECT CURRENT TO DIRECT CURRENT CONVERTER AIR DUCT
Install the second row seat.
Refer to: SECOND ROW SEAT - 90, BENCH TYPE
Power up the MHEV system.
Refer to: MHEV POWER DOWN/UP
Use the Jaguar Land Rover approved diagnostic equipment to configure the DC/DC converter.
General Equipment: Jaguar Land Rover approved diagnostic equipment