Electric Thermostat (G2417045): Installation

WARNING: This page is about a different variant/trim than selected.

- Install the new O-ring seal.
  Renew Part: Thermostat housing seal(s) Quantity: 1 .
- Install the electric thermostat.
- Install and tighten the 2 bolts.
  Torque : 12 Nm
- Install the engine coolant upper hose.
- Secure the 2 clips.
CAUTION: Make sure that the clip is correctly located.

Connect the engine coolant lower hose to the electric thermostat.
CAUTION: Make sure that the clips are correctly located.

Connect the engine coolant 2 side hoses to the electric thermostat.
Secure the electrical connector to the electric thermostat.
- Secure the wiring harness at the 4 clips.
- Connect the electrical connector to the electric thermostat.
- Install the A/C compressor bracket.
- Install and tighten the 4 bolts.
  Torque : 25 Nm
Install the A/C compressor.
Refer to: AIR CONDITIONING COMPRESSOR - INGENIUM I6 3.0L PETROL
Fill the engine cooling system with the correct amount of engine coolant.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING
Connect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT AND CONNECT